Construction worker on site
Work guide

Earplugs for work

Earplugs for work lower the noise reaching your ears so a loud shift stays within safe limits. In the UK, hearing protection must be made available above 80 dB(A) and worn above 85 dB(A). Start here for every Bollsen guide to choosing, fitting and wearing work earplugs, by trade and by law.

Shop WorkPRO2 pairs ship free · 40-day risk-free trial
By BOLLSEN Team · Updated 16 Oct 2026

Building sites, factory floors, warehouse aisles and workshops are often loud enough to damage hearing over a working life, and the damage builds up so slowly that most people only notice it years later. HSE estimates that around 15,000 people in Great Britain have work-related hearing problems. This page is the starting point for every Bollsen guide on hearing protection at work: what the law asks for, how much protection your job needs, and how to choose and wear it. If you already know you want to compare products, go straight to our best earplugs for work buyer guide, which sets reusable, foam, banded and custom earplugs and ear defenders (ear muffs) side by side.

When do you need hearing protection at work?

Under the Control of Noise at Work Regulations 2005, three numbers decide what happens. They refer to your average daily or weekly noise exposure, not to a single loud moment.

80 dB(A)

Your employer must make hearing protection available and tell you about the risk. Peak level 135 dB(C).

85 dB(A)

Wearing hearing protection becomes mandatory, and the area must be marked as a hearing protection zone. Peak level 137 dB(C).

87 dB(A)

The exposure limit, measured at the ear with your protection in. Peak level 140 dB(C).

The law expects noise to be cut at source first, with earplugs or ear defenders covering what is left, so hearing protection is one control in your employer’s duty, never the whole of it. The full text is on legislation.gov.uk and HSE explains it in plain English on its noise at work pages.

How loud is your job, and how much protection do you need?

Most power tools run at 85 to 110 dB(A) at the operator’s ear: a drill around 87 to 91 dB(A), a circular saw 94 to 98 dB(A) and a petrol chainsaw up to 120 dB(A). On the UK’s 3 dB rule, every 3 dB louder halves the safe time, so at 100 dB(A) the daily dose is used up in about 15 minutes. Our chart of how loud power tools are gives the level and safe time for each tool.

More protection is not always better. HSE advises aiming for about 70 to 78 dB(A) at the ear, and never below 70, because people who feel cut off pull their protection out to talk. Take your noise level, subtract the SNR (the UK and EU rating; the US uses NRR) and add 4 dB for real-world fit. Our guide to how much hearing protection you need walks through the sum with HSE’s selection bands.

Which guide fits your job?

Every workplace has its own noise sources and its own practical problems, from hard hats on site to forklifts in the aisles. Start with yours.

How do you choose and wear work earplugs?

The right protector depends on how loud your work is, how long you wear it, how often you take it out, and what else you wear on your head.

What must your employer do?

Your employer has to assess the noise, reduce it, provide protection, train you to use it and, in many jobs, check your hearing. You have duties too.

Is it safe to wear earplugs all shift?

Yes, for most people, when the earplugs are clean, fitted properly and not pushed in too deep. Wearing them for the whole time you are in noise matters more than the rating: protection taken out for even a short part of a loud shift loses much of its value. If you notice ringing or muffled hearing after work, speak to your GP or occupational health, and see the NHS guidance on hearing loss. Bollsen earplugs are hearing protection, not medical devices.

Where does WorkPRO fit?

WorkPRO earplugs (SNR 24 dB, £29.95) are our reusable earplug for work: a yellow, two-flange plug in soft, hypoallergenic silicone, tested to EN 352-2 in a German laboratory at SNR 24 dB (H 24, M 21, L 19). They are low-profile, so ear defenders fit over the top, and each pair is reusable up to 100 times. If you are unsure of your size, WorkPRO with AR KI TECH sizing (£44.95) measures your ears online from two photos.

To be honest about what they do: WorkPRO is a passive earplug, not a filter that picks out voices. Everything gets roughly 24 dB quieter, and high-pitched sounds are reduced a little more than low ones. A warning signal on a loud site stays audible because it is loud, not because the earplug lets it through. Using HSE’s bands, a 24 dB rating suits most jobs between about 90 and 100 dB(A). At 85 to 90 dB(A) it can over-protect, and above 100 dB(A) it belongs under ear defenders rather than on its own.

Want to see how WorkPRO compares with foam, banded and custom earplugs first? Our best earplugs for work guide compares them honestly, and a hearing specialist explains what to look for in hearing protection. Equipping a team? See our page on hearing protection for teams and bulk orders.

Recommended for work

Try WorkPRO

Reusable up to 100 times and made from soft, hypoallergenic silicone. Order 2 pairs and shipping is free to the UK, EU, US and worldwide.

WorkPRO
WorkPRO
4.8 (128 reviews)
  • 2 pairs ship free: UK, EU, US & worldwide
  • 40-day risk-free trial
  • Lifetime warranty

Frequently asked questions

At what noise level must you wear hearing protection at work?

In the UK, your employer must make hearing protection available from 80 dB(A) and make it mandatory from 85 dB(A). Exposure at the ear, with protection worn, must stay below 87 dB(A). The peak limits are 135, 137 and 140 dB(C).

Can you hear alarms with earplugs in at work?

Usually, yes. Passive earplugs make everything roughly 24 dB quieter, the alarm included. An alarm designed to sound above the background noise keeps that margin, so it stays audible because it is loud. Your employer should confirm this with a listening test.

Is an SNR 24 dB earplug enough for my job?

For most jobs between about 90 and 100 dB(A), yes. Subtract 24 from your noise level and add 4 dB for real-world fit, then aim for 70 to 78 dB(A) at the ear. Above 100 dB(A), wear earplugs under ear defenders.

Can you wear earplugs under ear defenders?

Yes. Low-profile earplugs such as WorkPRO sit flush in the ear so ear defenders fit over the top. Wearing both adds a few decibels over the better protector alone, not the sum of the two ratings.

How long do WorkPRO earplugs last?

Each pair is reusable up to 100 times. Wash them in mild soap and water, let them dry and store them in their case. Replace them sooner if they lose their shape or no longer seal.